For all of you that want to update your polymer bodied Ringsight with dead trijicon tubes and/or washed out reticle issues and don’t want to spend $400.00 to $600.00 to replace the White Ring Sight - THIS IS YOUR ANSWER!
The Reticule Enhancement Module T Bar 3 (REM T3) fixes the problem that is inherent in the White Ghost Ring Sight of the P90/PS90 Weapons System. We all know in certain low light conditions or when aiming at bright or light colored backgrounds, the Ring Sight looses its sight picture. When that happens just turn on the REM T3, and you will get a sharp T bar sight picture.
The REM T3 Illuminates the T bar of the Ring Sight via a green colored LED that sits in the rear light collector well. The LED housing is made of a hard plastic that is sized to create a tight friction fit. There is no need to use tape or glue. Just push it down into the light collector well and it stays put. The LED housing was designed to sit low in the well so it will not interfere with the FOV.
The REM T3 has 11 illumination settings so the T bar can be seen outdoors in daylight on its brightest setting (even against snow or white backgrounds) or in total darkness on its lowest setting. The REM T3 does not interfere with the Tritium illumination of the Ring Sight.
The REM T3 fits in the sling well just under the Ring Sight. It is ambidextrous so it can be mounted on the left or right side of the rifle.
The REM T3 uses one CR2032 3 volt battery (included.) The battery life is 106 hours of continuous use.
The REM T3 has a 1 YEAR Warranty. I will replace it if it fails due to a manufacturing problem. (I will have to examine it first to make sure there wasn't some other factor that caused the failure). You just pay for the shipping ($5.00). If after 1 year a manufacturing problem should occur... contact me and I will see what I can do for you.
The price is $39.95 shipped